We saw how to Backup Commissioning File and Save Snapshot ready and we detail how to check some configuration on SBTS in LMT such as VLANID, IP BTS, etc..

1. SBTS Name, ID and Profile

  • Parameters Go To Configuration Group Go To Site specific Go To Parameters



2. VLANID of SBTS

  • Parameters Go To Configuration Group Go To All parameters Go To Parameters  Go To Object (filter VLANIF)
Note: VLANIF-1 is OM, VLANIF-2 is 2G, VLANIF-3 is 3G and VLANIF-4 is 4G


3. IP Address of SBTS

  • Parameters Go To Configuration Group Go To All parameters Go To Parameters  Go To Object (filter IPIF)
Note: IPIF-1 is OM, IPIF-2 is 2G, IPIF-3 is 3G and IPIF-4 is 4G


4. Transmission Interface SRAN to Transmission

  • Parameters Go To Configuration Group Go To All parameters Go To Parameters  Go To Object (filter ETHLK)


This section, there are two case which we need to know.
a. Administrative State state of the Ethernet link : If  status unlocked, it means that SBTS service port is Enable. Otherwise, status locked, it means that SBTS service port is Disable.
b. Label of the connector by the ethernet link : If connectorLable is FSMF_EIF1_RJ45, it means that SBTS port service interface uses LAN cable. Otherwise, connectorLable is FSMF_EIF2_SFP, it means that SBTS port service interface uses Optical cable.

5. BSC IP

  • Parameters Go To Configuration Group Go To All parameters Go To Parameters  Go To Abbreviation (filter omu)
a. Management plane remote IP address for OMUSIG is mPlaneRemoteIpAddressOmuSig (BSC IP)

b. BSC identifier is identifier (BSCid) 


6. RNC IP

  • Parameters Go To Configuration Group Go To All parameters Go To Parameters  Go To Abbreviation (filter omu)
a. Far end SCTP subnet IP address is sctpFarEndSubnetIpAddress (RNC IP)

b. RNC identifier is identifier (RNC ID)


7. MME IP
  • Method 1: Parameters Go To Configuration Group Go To All parameters Go To Parameters  Go To Object (filter LNMME)

  • Method 2: Monitoring and Tests Go to IP Connectivity Test Go to Main MME